当前世界环境

Introduction

Taxonomically, soils of Madhya Pradesh are divided into four orders such as Inceptisols (27.65%), Entisols (12.97%), Vertisols (52.57%) and Mollisols (0.41%). This shows that soils of MP are rich vertisol type. The vertisol/black cotton soil is originated from lation word verto which means turn (Murthyet al.,1982). This order of mineral soils is characterized by high content of swelling type clays, which in dry seasons cause the soils to develop deep, wide cracks. The water holding capacity of this soils is high. The bulk density generally varies between 1.2 and 1.6 M gm^-3. The main constraints of this soil are low infiltration capacity and poor internal drainage, narrow workable soil water range, poor crop stand, evaporation from soil surface and shrinkage cracks. For these contratins the balanced and integrated use of plant nutrients as per soil value is the best strategy to maintain the soil health and crop productivity and yield. Therefore keeping these ideas in mind the present investigation "Influence of sustainable agricultural practices on chemical properties of vertisol soil with Soybean crop in Soybean-Wheat cropping sequence" was undertaken at Sehore district to represent the Central India.

Material and Methods

A field experiment was conducted during two consecutive years i.e. 2003-04, 2004-05 in the Rabi season respectively in medium black soil (vertisol) on "Influence of sustainable agricultural practices on chemical properties of vertisol soil with Soybean crop in Soybean-Wheat cropping sequence". The treatment applied to soil were Control (T₁), 100% NPK (T₂), 75% NPK (T₃), 50% NPK (T₄), 50% NPK+FYM (T₅), 100% NPK+FYM (T₆), 100% NPK+FYM (IPNM) (T₇). The treatments were replicated thrice in randomized block design (RBD). The Soybean CV JW-335 and the wheat CV GW - 273 variety was used for experiments. To study the chemical properties of soil, the soil samples were taken from 0-15, 15-30, 30-45cm depth before the sowing of the test crop from each plot. Further, these samples were mixed and a representative composite sample was prepared. It was air dried and processed with wooden pestle and mortar and passed through 2 mm sieve. It was stored and used for chemical analysis. The pH and electrical conductivity of soil was measured by Solubridge method (Piper, 1967) for this 1:2 soil water suspension solution was prepared and kept for over night and next day after method (Subbiah and Asija, 1956) was used for the estimation of available nitrogen. The Olsen's method (Olsenetal.,1954) was used for the determination of availablephosphorus. The potassium content was measured during study using flame photometric method (Toth and Prince, 1949). In the present study Barium Chromate method was used (Palaskaret al.,1981) for the estimation of sulphur. The Zinc (Zn) content was determined by using the method given by Lindasy and Norvell (1978). Where as the organic carbon and organic matter was determined by Walkley and Black method (1934).

Table 1: Chemical composition of soil (Vertisol) at different stages of soybean as influenced by different treatments under soybean-wheat cropping sequence experiments (mean of two years 2003-04 and 2004-05 Click here to view table

Table 2: Chemical composition of soil (Vertisol) at different stages of wheat as influenced by different treatments under soybean-wheat cropping sequence experiments (mean of two years 2003-04 and 2004-05 Click here to view table

Table 3: Chemical composition of soil (Vertisol) at different stages of soybean as influenced by different treatments under soybean-wheat cropping sequence experiments (mean of two years 2003-04 and 2004-05 Click here to view table

Results and Discussion

The pH of soil before experimentation with soybean crop was 6.86. After harvesting the pH values were observed minimum with T₁(control) and the maximum with T₇(100% NPK + FYM) (Table 1 and Fig. 1). The pH values for wheat crop before experimentation were the same as after soybean crop. The pH of soil after harvest showed the minimum value for T₇(100% NPK + FYM) and maximum with T₄氮磷钾(50%)(表2和图2),土壤EC性能试验ore experimentation with soybean crop was 0.34. After harvesting the EC values were found minimum for T₁(control) and maximum with T₇(100% NPK + FYM) (Table 1 and Fig. 1). The EC of soil before experimentation with wheat crop was the same as after harvest of soybean crop. After hasvesting the EC values were minimum for T₃(75% NPK) and T₇(100% NPK + FYM) while the ma maximum was with T₅T₄(50% NPK + FYM) (Table 2 and Fig. 2). The nitrogen content in soil before experimentation with soybean crop was 218.0 kg ha^-1. After harvesting the available nitrogen content was minimum observed with T₁(control) while the maximum T₇(100% NPK + FYM) (Table 3 and Fig. 1). The available nitrogen of soil before experimentation with wheat crop was the same as after harvest of soybean crop. After harvesting available nitrogen content was minimum observed with T₁(control) and the maximum for T₇(100% NPK + FYM) (Table 4 and Fig. 2). The phosphorus content in soil before experimentation with soybean crop was 17.80 kg ha^-1. After harvesting the available phosphorus was observed minimum with T₃(75% NPK) while the maximum with T₇(100% NPK + FYM) (Table 3 and Fig. 1).

Table 4: Chemical composition of soil (Vertisol) at different stages of wheat as influenced by different treatments under soybean-wheat cropping sequence experiments (mean of two years 2003-04 and 2004-05 Click here to view table

Figure 1: Chemical composition of vertisol soil at different stages of wheat as influenced by different treatments under soybean-wheat cropping sequence experiments (mean of two years 2003-04 and 2004-05 Click here to view figure

Table 5: Chemical composition of soil (Vertisol) at different stages of soybean as influenced by different treatments under soybean-wheat cropping sequence experiments (mean of two years 2003-04 and 2004-05 Click here to view table

The available phosphorus content in soil before experimentation with wheat crop was observed minimum with T₃(75% NPK) and the maximum with T₇(100% NPK + FYM). After harvesting the crop phosphorus content values were observed minimum with T₁(control) and the maximum T₇(100% NPK + FYM) (Table 3 and Fig. 1). The potassium content in soil before experimentation with soybean was 462.0 kg ha^-1. After harvesting the available potassium values was observed with T₁(control, T₄(50%NPK) and the maximum with T₇(100% NPK + FYM). After harvesting potassium content was noticed minimum (control) and the maximum was with T₇(100% NPK+FYM) (Table 4 and Fig. 2). The sulphur content in soil before experimentation with soybean crop was 12.92 kg ha^-1. After harvesting the available potassium values was observed with T₁(control) while the maximum T₇(100% NPK + FYM). After harvesting the available potassium values was observed with T₁(control) and the maximum T₇(100% NPK + FYM) (Table 5 and Fig. 1). The sulphur content in soil before experimentation with wheat crop was minimum with T₁(control) and the maximum T₇(100% NPK + FYM). After harvesting sulphur content was observed minimum with T₁(control) and the maximum was with T₇(100% NPK + FYM) (Table 6 and Fig. 2). The zinc in soil before experimentation with soybean crop was 0.28 ppm. After harvesting the available zinc value wasobserved minimum with T₁(control) while the maximum with T₇(100% NPK + FYM) (Table 5 and Fig. 1). The zinc content in soil before experimentation was observed minimum with T₁(control) while the maximum T₇(100% NPK + FYM). After harvesting zinc content values were observed minimum with T₁(control) and the maximum was with T₇(100% NPK + FYM) (Table 6 and Fig. 2). The data obtained on organic carbon for soybean crop were observed minimum for T₁(control) and the maximum was for T₇(100% NPK + FYM) (Table 6 and Fig. 2). The data obtained or organic matter for soybean crop the minimum values were observed for T₁(control) while the maximum was T₇(100% NPK + FYM) (Table 5 and Fig. 1). The data obtained for the organic matter in soil with wheat crop were noticed minimum with T₁(control) while the maximum with T₇(100% NPK + FYM) (Table 6 and Fig. 2).

图2:变性土土壤的化学成分different stages of soybean as influenced by different treatments under soybean-wheat cropping sequence experiments (mean of two years 2003-04 and 2004-05 Click here to view figure

Table 6: Chemical composition of soil (Vertisol) at different stages of wheat as influenced by different treatments under soybean-wheat cropping sequence experiments (mean of two years 2003-04 and 2004-05 Click here to view table

As per data shown in tables N, P and K contents were significantly influenced at different stages of soybean and wheat crops in all the treatments the maximum with impact was noticed with T₇treatments increased in contents may be due to the application of different IPNM treatments. Like wise sulphur and zinc contents were significantly increased with different doses. This was due to synergistic relationship between potassium with sulphur and zinc. The data obtained on organic carbon and organic matter indicated that these contents were significantly influenced by different IPNM treatments over that of control. The T₂, T₅, T₆and T₇treatment were found to be statistically at par.

These results are in close agreement with those obtained by Rajput and Sastry (1988a, 1988b), Jain and Vyas (2003). The increasing trend in organic carbon and organic matter contents could be ascribed due to the addition of FYM in the soil and the added crop residues during the growth period of soybean leading to the enchanced organic carbon and organics matter content after harvest of crop in the soil.

References

1. Jain, R.C. and Vyas, M.D., Improvement of component of agro-technologies for management of intercrops. In. National agricultural technology project completion report. April 2000-Dec-2003, (2003) 1-31.
2. Lindsay, W.L. and Norvell, W.A., Development of DTPA soil test for zinc, manganese and copper.,Soil Sci. Soc. Am.J.,(1978) 42: 421-428.
3. Murthy, R.S., Bhattacharyee, J.C., Lande, R.J. and Pofali, R.M., Distribution, characteristics adn classification of verticals.Trans. In. 12^thInternation Congress SoilScience, New Delhi, Symposium Paper - II,(1982) 3-22.
4. Olsen, S.R., Cole, C.V., Watanabe, F.S. and Alan, L.A., Estimation of available phosphorus in soils by extraction with sodium bicarbonate In. USA Circular, (1954) 939.
5. Plaskar, M.S., Babrekar, P.G. and Ghosh, A.B., "A rapid analytical technique to estimate sulphur in soil and plant extracts.J. IndianSoc. Soil. Sci.,(1981) 29: 249-256.
6. Piper, C.S., In. Soil and Plant Analysis. Asia Publishing House, Bombay, India (1967).
7. 拉其普特人,r和Sastry P.S.N,土壤的影响endment of soil physico-chemical properties of sandy loam soil II structural and hydro-physical properties.Indian. J. Agric.Res.,(1988a) 22(4): 209-216.
8. 拉其普特人,r和Sastry P.S.N,土壤的影响endment of soil physico-chemical properties of sandy loam soil III-Static and water retention properties.Indian. J. Agric.Res.,(1988b) 22(4): 197-202.
9. Subbiah, B.V. and Asija, R.L., A rapid procedure for the determination of available nitrogen in soils.,Curr. Sci.,25: 259-260.
10. Toth, S.J. and Prince, A.L., Estimation of C.E.C. and exchangable Ca, K, and Na contents of soil by flame photometer technique.Soil Sci.,(1949) 67: 439-445.
11. Walkley, A. and Black, I.A., "An examination of the Degtjareff method for determination soil organic matter and a proposed modification of the chromic acid titration method.Soil Sci.,(1934) 34: 29-38.